Nánari upplýsingar

DJI Power 1000

Power Your World

 

Safe and Secure, Inside and Out

 

 

1024Wh Capacity Charging Ability 

 

 

Smáa letrið:

* The appearance of products sold in different countries and regions may vary. Refer to the actual item.

  1. Available when the product’s battery level is above 20%.
  2. Device power does not exceed 2000 W.
  3. Data tested under laboratory conditions at 25° C (77° F) and should be used for reference only.
  4. Each USB-C port supports a max output power of 140 W. The device being charged must support the PD 3.1 protocol and use a USB cable that meets EPR specifications.
  5. Requires certain accessories, which are sold separately.
  6. DJI Power 1000 units purchased from the DJI Store will have a three-year warranty, which can be extended by an additional two years after registration. Consult customer service on DJI Store for more details.
  7. Supports DJI Mavic 3 Pro Series, Mavic 3 Classic, Mavic 3 Series, and Mavic 3 Enterprise Series.
  8. DJI Power 1000 can connect to up to two DJI Power Solar Panel Adapter Modules (MPPT), which can then connect up to three solar panels, meaning up to six solar panels can be connected to DJI Power 1000 at the same time. Additionally, DJI Power 1000 can connect to one solar panel through the DJI Power Car Power Outlet to SDC Power Cable.
  9. Requires the DJI Power Solar Panel Adapter Module (MPPT) and solar panels. The aforementioned accessories are sold separately. The minimum time to fully recharge was measured under 25° C (77° F) laboratory conditions and is for reference only. Actual recharging time is subject to factors like the angle of sunlight and light intensity. Actual user experience may vary. To use solar panels not officially recommended by DJI, convert the solar panel connector to an XT60 interface. To prevent damage to the MPPT module and the power station, ensure the open-circuit voltage of each solar panel is less than 30 V. The power output of each solar panel connected to a single XT60 interface should not exceed 200 W, with the total output power of solar panels connected to the entire MPPT module capped at 400 W.
  10. Measured under 25° C (77° F) laboratory conditions, being recharged in the 600W Standard Recharge Mode, and at an output power of 1000 W.
  11. Based on the correct usage of the product, DJI Power 1000 will have an approximate lifespan of 10 years, calculated on the basis of completing one full recharge/discharge cycle on a daily basis. This data is for reference only. Actual user experience may vary.
  12. Data measured in a DJI laboratory.
  13. Measured 100 cm away from DJI Power 1000 while it was being recharged in the Standard Recharging Mode and is for reference only.
  14. During power output, the device being charged must support the PD 3.0 protocol. During power input (recharging the power station), the charger must support the PD 3.0 protocol.

DJI Power 1000

169.990 kr.

  • 2400W Max Output Power [1]
  • Fully Charged in 70 Mins [3]
  • Supports Solar Charging
  • Ultra-Quiet Operation
  • Dual PD 3.1 USB-C Out Ports (140W Max) [4]
  • Up to 5 Years of Warranty
  • Comprehensive Safety
  • Fast Charges DJI Drones [5]

Ekki til á lager

Viltu fá tilkynningu þegar þessi vara er aftur á lager?

Nánari upplýsingar

DJI Power 1000

Power Your World

 

Safe and Secure, Inside and Out

 

 

1024Wh Capacity Charging Ability 

 

 

Smáa letrið:

* The appearance of products sold in different countries and regions may vary. Refer to the actual item.

  1. Available when the product’s battery level is above 20%.
  2. Device power does not exceed 2000 W.
  3. Data tested under laboratory conditions at 25° C (77° F) and should be used for reference only.
  4. Each USB-C port supports a max output power of 140 W. The device being charged must support the PD 3.1 protocol and use a USB cable that meets EPR specifications.
  5. Requires certain accessories, which are sold separately.
  6. DJI Power 1000 units purchased from the DJI Store will have a three-year warranty, which can be extended by an additional two years after registration. Consult customer service on DJI Store for more details.
  7. Supports DJI Mavic 3 Pro Series, Mavic 3 Classic, Mavic 3 Series, and Mavic 3 Enterprise Series.
  8. DJI Power 1000 can connect to up to two DJI Power Solar Panel Adapter Modules (MPPT), which can then connect up to three solar panels, meaning up to six solar panels can be connected to DJI Power 1000 at the same time. Additionally, DJI Power 1000 can connect to one solar panel through the DJI Power Car Power Outlet to SDC Power Cable.
  9. Requires the DJI Power Solar Panel Adapter Module (MPPT) and solar panels. The aforementioned accessories are sold separately. The minimum time to fully recharge was measured under 25° C (77° F) laboratory conditions and is for reference only. Actual recharging time is subject to factors like the angle of sunlight and light intensity. Actual user experience may vary. To use solar panels not officially recommended by DJI, convert the solar panel connector to an XT60 interface. To prevent damage to the MPPT module and the power station, ensure the open-circuit voltage of each solar panel is less than 30 V. The power output of each solar panel connected to a single XT60 interface should not exceed 200 W, with the total output power of solar panels connected to the entire MPPT module capped at 400 W.
  10. Measured under 25° C (77° F) laboratory conditions, being recharged in the 600W Standard Recharge Mode, and at an output power of 1000 W.
  11. Based on the correct usage of the product, DJI Power 1000 will have an approximate lifespan of 10 years, calculated on the basis of completing one full recharge/discharge cycle on a daily basis. This data is for reference only. Actual user experience may vary.
  12. Data measured in a DJI laboratory.
  13. Measured 100 cm away from DJI Power 1000 while it was being recharged in the Standard Recharging Mode and is for reference only.
  14. During power output, the device being charged must support the PD 3.0 protocol. During power input (recharging the power station), the charger must support the PD 3.0 protocol.
Scroll to Top